1. Connect L and N to the power supply of AC220V/50HZ; AC110V/60HZ;
L is Live wire, N is Neutral wire, PE is grounding wire.
2. Connect LAMP to D1, D2; voltage: AC220V/50HZ; AC110V/60HZ.
3. Connect the motor wire U to the REV motor wire, connect W to the
FWD motor wire, and connect V to the motor common wire.
4. Connect C, C to the capacitor wire.
Sliding Gate Opener
24VDC Power supply for fittings +24VDC （Electric current ≤50mA） ;
GND Power ground;
I.R Photo cell input (N.C.);
CLLM Close limit switch;
COM Limit switch common terminal;
OPLM Open limit switch.
COM Control button common terminal;
STP Stop control button (N.O.);
CLS Gate close control button (N.O.);
OPN Gate open control button (N.O.)
1. Sliding Gate Opener External button switch. ON - Three button switch; OFF - Single button
switch (X7 terminal CLS button can be used to circularly control
OPEN/STOP/CLOSE/STOP of the main engine)
2. Automatic close time.
3. Automatic close time.
Setting for automatic close time:
2 ON 3 OFF: automatic Sliding Gate Opener close time is 15s,
2 OFF 3 ON: automatic close time is 30s,
2 OFF 3 OFF: automatic close time is 45s,
2 ON 3 ON: no automatic close function.
Sliding Gate Opener Infrared connection Infrared photocell function:
In the closing process, when infrared ray of the photocell is covered by
people or objects during its detection range, the gate will open
immediately for security protection.
The distance between photocell receiver and photocell emitter should be
more than 2 meters,otherwise will affect the induction of the photocell.
If connect the infrared photocell, please remove the short connection
between I.R and GND on the X5 termina.